2000 Series Dual Mode Servo (25-3, Speed)

SKU:
$33.99

Meet the Dual Mode ‘SPEED’ Servo.  This servo is essentially the original 2000-0025-0002 ‘TORQUE’ Servo, but with a lower ratio to achieve a quicker transit speed!  Over 2x faster than its counterpart, this servo saves valuable time where it counts!

Just like the 25-2, this servo boasts two different modes which allow it to fill a variety of roles on your robot or project.  In the default mode, the servo is able to rotate 300 degrees while having positioning feedback. In this mode, the PWM signal will determine the position of the servo.  Using the 3102 Series Dual Mode Servo Programmer (1-1) the servo can be toggled into continuous rotation mode.  In this mode, the servo will have proportional speed control based on the PWM signal that you send with your servo controller.

Downloads

Specs

Weight 58g
Gear Ratio 135:1
Output Shaft Style 25 Tooth Spline
Voltage Range 4.8V ~ 7.4V
No-Load Speed (4.8V) 0.11 sec/60° (90RPM)
No-Load Speed (6.0V) 0.09 sec/60° (115RPM)
No-Load Speed (7.4V) 0.07 sec/60° (145RPM)
Stall Torque (4.8V) 7.9 kg.cm (110 oz-in)
Stall Torque (6.0V) 9.3 kg.cm (130 oz-in)
Stall Torque (7.4V) 10.8 kg.cm (150 oz-in)
No-Load Current (4.8V) 190mA
No-Load Current (6.0V) 200mA
No-Load Current (7.4V) 230mA
Stall Current (4.8V) 2000mA
Stall Current (6.0V) 2500mA
Stall Current (7.4V) 3000mA
Max PWM Range (Default) 500 - 2500μsec
Max PWM Range (Continuous) 1000 - 2000μsec
Travel per µsec (Default) 0.15°/μsec
Max Travel (Default) 300°
Pulse Amplitude 3-5V
Direction Clockwise w/ Increasing PWM Signal
Deadband Width 4μsec
Motor Type Brushed DC
Feedback Style 5KΩ Potentiometer
Output Shaft Support Dual Ball Bearing
Gear Material Steel
Wire Length 300mm
Wire Gauge 22 AWG
Connector Type 3-Pos TJC8 Servo Connector [MH-FC]

This website uses cookies to ensure you get the best experience on our website